TopFlyTech T8603

Topflyt8603

Connection Parameters

Server Address server.gp-s.net
Server IP 136.244.102.118
Server Port 47744
Desteklenen Fonksiyonlar
95%
Otomatik Aktivasyon
100%
Sunucu Uptime
99%

Bu cihaz sistemimiz ile uyumludur, Eğer bu model bir cihaza sahipseniz cihazınızı online otomatik aktivasyon ile sistemimize transfer ederek, GP-S.Net ‘in ekonomik tarifeleri ile tasarruf eder ayrıca tüm özelliklerinden ve mobil uygulamalarından faydalanabilirsiniz.

Açıklama

TopFlyTech T8603 is a very simple OBDII-type tracker. It does not read any OBD II information, but it uses power supply from OBD II port. No special skills required for the installation ? just plug it to the car diagnostic port.

Location and tracking
T8603 model is embedded with GPS and doesn?t have support of GLONASS or alternative systems. It neither supports Assisted GPS technology. As the back-up, when no satellites signals are available, it uses Cell ID location (also known as LBS-tracking).

OBDII data reading
T8603 is a simple tracker. It only gets power supply from OBDII port, but it does not read any data from vehicle CAN bus or K-Line. With T8603 you will be unable to get telemetry from onboard diagnostic system, ?heck engine lamp (MIL) or DTC codes.

Mobile networks
With Quad-band GSM module T8603 can be operated in 2G networks all over the world.

Power supply
T8603 uses OBD II Connector Type B (9 of 16 pins used) and voltage range 6-36V, which makes possible to install T8603 both on cars and trucks.

T8603 also features a built-in rechargeable backup battery. When fully charged it ensures about 1-2 hours of device operation (in normal conditions).

When being unplugged from the OBDII socket the device sends notification to server.

Remote management
T8603 tracker can be fully controlled over GPRS, including configuration of tracking modes. There is also a wide list of SMS commands in a human-friendly format, on which device always replies back.

It supports remote configuration of APN settings, server address and port by SMS.

LED Indication
T8603 has two LEDs
Red LED indicates GSM/GPRS mode
Blue LED indicates GPS receptio
The light goes out automatically in five minutes after the device is plugged into OBDII port.

Additional notes
In some cars it?s not possible to read the Ignition state from the OBDII port. Then T8603 uses proprietary algorithm based on multiple parameters to evaluate the Ignition is ON with 98% accuracy. And the same algorithm it uses to detect the car engine is OFF and reduces the power consumption.

Compared to other OBDII trackers, T8603 seems a little longer. It might cause the device don?t fit the interior details in some cars. To overcome this problem an OBDII extension cable (optional accessory) can be used.

To switch device off (even with charged battery) just remove the SIM card. The device will switch off in 5-10 seconds.

General information
Purpose Vehicle
Installation Not required
Special form factor OBDII Dongle
Housing
Size 63x47x26.5 mm (2.48×1.85×1.04 in)
Weight 60 g (2.12 oz.)
GNSS Location
GPS
Internal antenna (GNSS)
External antenna (GNSS)
Assisted GPS
Connectivity
Cellular network type GSM Quad Band
Cellular network generation 2G
Internal antenna (Connection)
External antenna (Connection)
Interfaces
ACC/Ignition input Feature already supported
Discrete inputs Feature already supported
Outputs
Hardware features
Built-in battery
Battery capacity 280 mAh
Emergency button
Detach sensor Feature already supported
Non-volatile memory
Hardware extras
Fuel level sensor reading
Fuel temperature sensor reading
Driver ID reading
Engine block special control Feature already supported
Emergency button
Tracking features
Tracking modes Continuous
Smart power consumption
Odometer
ECO driving
Events monitoring
External power cut off Feature already supported
Battery low Feature already supported
Device switched on/off Feature already supported
Towing Feature already supported
Fall/Shake Feature already supported
Self monitoring
Network signal level
GNSS signal level Feature already supported
GNSS satellites fixed Feature can be supported upon request
External power source voltage
CAN/OBDII reading
CAN/OBDII reader type
DTC codes reading
Check engine light
Remote management
Server connection setup over SMS Feature already supported
Remote device configuration Yes (over GPRS)
Forced GNSS location update over SMS
Forced LBS location update over GPRS
Message exchange format BINARY
Firmware update OTA
Certification
CE
FCC

Bu cihazı başka bir yerden satın aldım sisteminizi kullanabilirmiyim?

Evet, cihazınızı kolaylıkla sistemimize aktarabilir ve mobil uygulamalarımız dahil tüm özelliklerinden faydalanabilirsiniz.

Cihazımı nasıl GP-S.Net ' e transfer edebilirim?

Bu konuda endişelenmeyin GP-S.Net’ in benzersiz otomatik aktivasyon özelliği sayesinde herşey online ve otomatik olarak gerçekleşir.

Aktivasyon yada transfer işlemi ne kadar sürer?

Sadece bir kaç dakika sürmektedir, cihazınızı sökmeniz yada bilgisayara bağlamanız vb. işlemler gerektirmez, otomatik aktivasyon çok kolaydır, herhangi bir teknik bilgi gerektirmez ama olurda yardıma ihtiyaç duyarsanız bizimle irtibata geçin tüm işlemleri sizin adınıza yapabiliriz.

Sepetiniz şu anda boş.

Mağazaya geri dön